Today I cut the plywood for the back panal of my project. I also put my Kreg Jig to good use by drilling lots of holes in preparation for the time when I will be able to assemble the dresser together.
I also continued working on the side panels that I glued the other day. I measured the thickness of the wood, one inch.
Then I set the depth collar for the drill bit at one inch.
Next I set the jig to the one inch mark.
Then I drilled the pocket using my corded Ryobi drill.
Finally, I test drove a screw through the hole to check it.
I did this a lot today and in the end I was proud of my little shavings pile!
No comments:
Post a Comment